cnc pipe end forming machines automatic classification methods are many, according to different methods can be divided into a variety of categories, according to the structure can be divided into: Single-head cnc pipe end forming machines automatic, double-head cnc pipe end forming machines automatic, vertical cnc pipe end forming machines automatic, etc., according to the working mode can be divided into:,,, etc. So what do you need to pay attention to before operation?

1, the machine must be well grounded, the wire must not be less than 4mm2 copper flexible wire. Do not allow access to exceed the specified range of power supply voltage, do not plug and unplug plug-in live, do not use a megohm meter to test the control loop, otherwise it may damage the device.

2. When inserting and removing the connector, do not pull out the wire or cable to prevent the welding from pulling out.

3, proximity switches, encoders, etc. can not be hit with hard objects.

4, can not use sharp objects collision display unit.

5, the electrical box must be placed in a ventilated place, prohibited to work in dust and corrosive gases.

6. Do not install or change PC input and output terminals without permission.

7. When replacing the power supply of the machine tool, the motor steering must be reconfirmed.

8, the machine tool should be kept clean, special attention should be paid to the clamping block, slide block and other sliding slot should not have foreign bodies.

9. Add lubricating oil to the chain and other sliding parts regularly.

10. The power supply must be disconnected during cleaning and maintenance.

11, before starting: check whether the oil level of the fuel tank to the oil level line, each lubrication point refueling, start to confirm the motor steering, check the oil pump for abnormal sound, check the hydraulic system for oil leakage after starting (Angle encoder is not allowed to refueling);

12, pressure adjustment: Use the electromagnetic relief valve to adjust the pressure to ensure that the system pressure reaches the required working pressure, generally not higher than 12.5Mpa.

13, mold adjustment: mold installation, requires the mold and clamping block to the center, clamping block can be adjusted by bolts; The booster block is centered on the mold, and the booster block is adjustable; Center the core head with the mold, loosen the core head frame bolt, adjust the center and tighten the bolt.

cnc pipe end forming machines automatic https://www.john-sheng.com/CNC-Tube-End-forming